Ricoh WG-M2 - Turning the camera on and off; Initial settings

2
13
Getting Started
3 While the camera is turned
off, slowly insert the
memory card into the
microSD card slot in the
direction of the arrow.
4 Close the battery/card cover.
Close the battery/card cover until it clicks.
Next, move the lock lever to the left side and lock the
release latch.
u Caution
• Do not apply excessive force when opening and closing the
battery/card cover because the waterproof seal may peel off.
If the seal is not in the correct position, the camera will not be
waterproof.
• If the battery/card cover is not locked securely, water, sand,
or dirt may get into the camera.
• This camera uses a specifically designed D-LI68
rechargeable lithium-ion battery. Use of any other type of
battery may damage the camera and cause malfunctions.
• Insert the battery correctly. If the battery is not inserted
correctly, it may cause malfunctions.
• When storing the battery for more than 6 months, charge the
battery for 30 minutes using the power adapter and store the
battery separately. Be sure to recharge the battery every 6 to
12 months. Storing the battery below room temperature is
ideal. Avoid storing it in high temperatures.
• The date and time may be reset to the default settings if the
camera is left without the battery for a long time.
• Be careful as the camera or the battery may become hot
when the camera is used continuously for a long period of
time.
• Allow the camera to dry completely before changing the
battery or memory card. Avoid changing the battery or
memory card where the camera is likely to get wet or dirty,
and make sure that your hands are dry.
• Be sure to use this camera to format (initialize) a memory
card that is unused or has been previously used on other
cameras or digital devices. Refer to "Formatting" (p.43) for
instructions on formatting cards.
• Make sure that the camera is turned off before inserting or
removing the battery or memory card.
t Memo
• The camera does not come with a memory card. You must
purchase one separately. (Use a microSD card of Speed
Class 10 or higher. For d movies set to z, use a microSDXC
card of UHS-I Speed Class 3.)
• To remove the memory card, first open the battery/card
cover. Press the card in lightly with your finger until the card
pops out, then pull it straight out.