Machine Storage
Store the tool in a locked area that is
out of reach of children and people unfamiliar with roll
groover equipment. This tool can cause serious injury in
the hands of untrained users.
Service and Repair
WARNING
Improper service or repair can make machine
unsafe to operate.
The “Maintenance Instructions” will take care of most of
the service needs of this machine. Any problems not
addressed by this section should only be handled by an
authorized RIDGID service technician.
Tool should be taken to a RIDGID Independent Author -
ized Service Center or returned to the factory.
When servicing this machine, only identical replacement
parts should be used. Use of other parts may create a risk
of serious injury.
Figure 21
4. Replace the groove roll shaft and the set screw.
5. Visually inspect the alignment between the groove roll
and the drive roll. If they are not aligned, check ori-
entation of groove roll and thrust washer.
6. Grease as directed in Lubrication Section of manual.
Accessories
WARNING
The following RIDGID products have been designed
to function with the 975 Combo Roll Groover. Other
accessories suitable for use with other tools may be
hazardous when used on the 975 Combo Roll
Groover. To reduce the risk of serious injury, only
use accessories specifically designed and recom-
mended for use with the 975 Combo Roll Groover,
such as those listed in the chart.
Ridge Tool Company18
975 Combo Roll Groover
WARNING
Cat. Number Description
41855 300 Power Drive, 115V 25-60Hz 38RPM
75075 300 Power Drive, 115V 23-60Hz 57RPM
42360 1206 Stand for 300 Power Drive
66947 300 Compact, 115V 50/60Hz 38RPM
73447 300 Compact, 115V 50/60Hz 52RPM
67662 Adapter Bracket for 300 Compact
67657 250 Folding Wheel Stand for 300 Compact
72037 460 Portable TRISTAND Chain Vise
56662 VJ-99 VHead High Pipe Stand
76822 Inch Diameter Tape
76827 Metric Diameter Tape
30708 Extension,
1
/
2
" Drive, Locking
30703 Ratchet,
1
/
2
" Drive With 90° bend
32833 Groove and Drive Rolls for 2" - 8" Copper
Tube Type K, L, M and DWV
Main Housing
Set Screw
Thrust
Washer
Groove
Roll
Slide
Block
To Next Page
Loading...
