20
gEbruIk
If more than one machine is connected
to the extraction unit, each machine
must be shut o with a slider from the
extraction unit. Make sure that the sli-
ders on the machines that are not being
used are closed. Use of automatic sliders
is recommended.
The extraction unit DM-300 was built ac-
cording to the GS-HO-07, version 11.2015,
and are tested to this standard by the Prüf-
und Zertizierungsstelle der Holzgenos-
senschaft, Vollmoellerstrasse 11, D-70563
Stuttgart. The extraction units are there-
fore suitable for extracting and separating
dry (moisture content <30%) wood dust
and chips, whereby the residual materi-
al standard 3 (H3): 0.1 mg/ m is certainly
achieved.
The extraction unit is not suitable for the
extraction of:
• Sticky substances such as glue residu-
es and overspray
• Welding smoke, smoke, etc.
• Spark-forming machines, such as me-
tal grinding machines
• Liquids
• Explosive or equivalent substances, ac-
cording to §1 of the German explosives
law, SprenG, or substances from dust
explosion class St 3.
The extraction unit must not be placed in a
potentially explosive environment.
The extraction unit can only be set up out-
side if it is suciently protected against
rainwater.
connEctIng multIplE machInEs
4.6
rEstrIctIons on usE
4.7
lImItatIons of sEtup4.8
To Next Page
Loading...