OIL BURNER COMPONENTS IDENTIFICATION
STANDARD RIELLO OIL BURNER MODELS 40 F3 & 40 F5 BURNER KEY COMPONENTS
1. 530 SE/C INTEGRATED PRIMARY CONTROL
2. PRIMARY CONTROL SUB-BASE
3. FUEL UNIT (PUMP)
4. PSC MOTOR
5. CAPACITOR
6. AIR ADJUSTMENT AND SHUTTER
7. ELECTRONIC AIR SHUTTER ASSY.
8. WIRE HARNESS FOR AIR SHUTTER
9. COMBUSTION HEAD WITH DRAWER ASSY.
10. SEMI FLANGE 2 PIECES
11. UNIVERSAL MOUNTING FLANGE & GASKET
12. AIR TUBE COVER PLATE
13 PUMP VALVE (COIL)
*PLEASE READ THE MANUAL FOR SPECIFIC INFORMATION ON COMPONENTS
**IF BURNER IS AN OEM BURNER KEY COMPONENTS MAY DIFFER SLIGHTLY
BURNER SERIAL NUMBER IDENTIFICATION
The Riello 15 character serial number, exmnple, 99 A 8511111 00025, is identified as follows:
99 = last two digits of the year of manufacture; A = BI-week of manufacture; 8511111 = burner product code;
00025 = increment of 1 for each burner produced - specific to product code - reset to zero each January 1st.
...._/ (99) (A) 8511111 00025
...---I--I
Year ofmanuIhcture I BI-weekofmanufacture ] [ Burner product code ] I Sequence ]
INITIAL SET-UP
A) Remove burner and air tube from cartons. Check parts list (inside cover) to ensure all parts are present.
B) Remove burner cover by loosing the three screws securing it. Remove control box and air tube cover (see
page 8).
C) Remove drawer assembly from air tube, insert nozzle and set Turbulator adjusnnent for specific input
required (see pages 8 & 9), then set aside.
D) Mount air tube to burner chassis. (see next page)
Standard 40 F3-F5 I-O manual Rev4 l.doc Page 5 of 5
To Next Page
Loading...
