APPLICATION FIELD WIRING
WIRING DIAGRAM SHOWN BELOW FOR STANDARD RIELLO 530 SE/C PRIMARY CONTROL BOX
INSTALLATION NOTE: ELECTRONIC AIR SHUTTER REQUIRES A CONSTANT 120V POWER
SUPPLY TO THE AUX TERMINAL, FAILURE TO PROVIDE THIS WILL RESULT 1N NO BURNER
OPERATION OR AIR SHUTTER WILL NOT CLOSE.
RECOMMENDED FIELD WIRING FOR
TYPICAL APPLICATIONS
120V OPERATED SYSTEMS
L
@,
D
120VAC 60HZ.
_ Q
24V OPERATED SYSTEMS
N d _ L _ SH_ER
120VAC 60HZ.
Q
T
O
WIRIN( 1,I ( t ND:
PI,I ASI NE)II : OPI RAF[N( l,IMIl AND SAFI'IY I,IMI'I ARI FWO SI PARAFI I,IMI'IS
(1) MAIN DISCONNEC'I FUSE
(2) MANUAL SERVICE SWHCH
(S) "SAFE_IY" I,IMII" DEVICt "
(4) "E)Pt'RA'IING " I IMI'I DEVICt"
(5} t'AR'Itt GROUND CONNEC'IIE)N BURNt'R CtIASSIS
(6) BURNER CON1ROL REMOI'E LE)CK OlJ'I ALARM DtVICE WIRt'D _" SUPPIIED BY O FItteRS
(AUX) AUXILIARY SUB BASE ADD ON CE)NNt C'IOR (AIR SHU FI'ER)
(1 F)24V FHERMOSFAF CE)NNECl[E)NS LE)W VOI'IACE E)PERA Ft'I) SYS1EMS
M[N \VIRI SIZtI:
[NSULA'IED 18 A\VG SOI1D OR 1(_ S ['RI)
R A F B I) l 05 ° C
PROPt R IARltt (ROUNDING MtANS RIQ'D
ALL WIRING StIOWN PROVIDED BY O'[tI[ RS
WARNING: DO NOT activate burner until proper oil line connections have been made, or I
failure of the pump shaft seal may occur.
I
WARNING: DO NOT activate burner until all safety and operating controls have been I
wired in series with the burner, as required by local code authorities and/or as specified by
I
the appliance manufacturer.
Standard 40 F3-F5 I-O manual Rev4 l.doc Page 9 of 9
To Next Page
Loading...
