Need help?Do you have a question about the Riello SDH 1000 UL and is the answer not in the manual?
Shows the front panel layout and components of the UPS unit.
Details the rear panel connections and ports for different UPS models.
Verifies that all items are present after opening the UPS package.
Specifies the required environmental conditions for UPS and battery box installation.
Instructions for installing optional battery boxes with the UPS.
Covers setting battery capacity, tower, and rack installation configurations.
Guide for initial connection and powering up the UPS system.
Procedures for powering the UPS on from mains/battery and switching it off.
Explains various icons and messages displayed on the UPS panel.
Details the meaning of different status icons shown on the UPS display.
Describes how to view measurements and interpret display codes.
How to access and modify UPS settings via the display panel.
Lists and explains various configurable parameters for the UPS.
Overview of ViewPower software for UPS management and monitoring.
How to use ViewPower for configuring UPS settings and status.
Pinout and signal information for the RS232 communication port.
Details the expansion slot for optional communication cards.
Categorization of fault alerts, including anomalies and critical alarms.
Indicates the presence of active remote commands like EPO.
Explains lock alerts, their causes, and consequences on UPS operation.
Shows the front panel layout and components of the UPS unit.
Details the rear panel connections and ports for different UPS models.
Verifies that all items are present after opening the UPS package.
Specifies the required environmental conditions for UPS and battery box installation.
Instructions for installing optional battery boxes with the UPS.
Covers setting battery capacity, tower, and rack installation configurations.
Guide for initial connection and powering up the UPS system.
Procedures for powering the UPS on from mains/battery and switching it off.
Explains various icons and messages displayed on the UPS panel.
Details the meaning of different status icons shown on the UPS display.
Describes how to view measurements and interpret display codes.
How to access and modify UPS settings via the display panel.
Lists and explains various configurable parameters for the UPS.
Overview of ViewPower software for UPS management and monitoring.
How to use ViewPower for configuring UPS settings and status.
Pinout and signal information for the RS232 communication port.
Details the expansion slot for optional communication cards.
Categorization of fault alerts, including anomalies and critical alarms.
Indicates the presence of active remote commands like EPO.
Explains lock alerts, their causes, and consequences on UPS operation.
General| Topology | Line-Interactive |
|---|---|
| Power Rating | 1000 VA |
| Output Voltage | 120/230 VAC |
| Output Frequency | 50/60 Hz |
| Communication Interface | USB, RS232 |
| Battery Type | Sealed Lead Acid |
| Transfer Time | 4 ms |
| Waveform | Simulated Sine Wave |
| Operating Temperature | 0°C to 40°C |
| Operating Humidity | 0% to 95% (non-condensing) |
| Safety Approvals | CE |
To Next Page