Need help?Do you have a question about the Riello Sentinel Dual SDL 4000 and is the answer not in the manual?
Overview of the UPS unit's front and rear panels.
Details of the LCD display and its indicators.
Steps to unpack and verify UPS components.
Instructions for configuring the UPS in a vertical (tower) orientation.
Instructions for converting the UPS for rack-mounted installation.
Initial setup, connection, and power-on procedures.
Procedure to power up the UPS using the mains supply.
Procedure to power up the UPS using battery backup.
Steps to safely turn off the UPS.
Explanation of various status icons displayed on the UPS panel.
How to interpret and navigate measurement readings on the display.
Details on accessing and modifying UPS operating parameters.
Explanation of different operational modes like ON LINE, ECO, SMART ACTIVE.
Overview of configurable parameters and their settings.
Description of available RS232, USB, and expansion communication ports.
Information on monitoring, control, and configuration software.
Step-by-step guide for replacing the UPS battery.
List and explanation of FAULT, Alarm, and LOCK codes.
Instructions for fitting ferrite cores for EMI reduction.
General| Power Rating | 4000 VA |
|---|---|
| Input Voltage | 230 V |
| Transfer Time | 0 ms |
| Form Factor | Tower |
| Operating Temperature | 0 to 40 °C |
| Storage Temperature | -15 to 45 °C |
| Humidity | 0-95% non-condensing |
| Certifications | CE, EN 62040-1, EN 62040-2 |
| Output Voltage | 230 V |
| Frequency | 50/60 Hz |
| Waveform | Sine Wave |
| Battery Type | VRLA |
| Typical Recharge Time | 4-6 hours to 90% capacity |
| Communication | USB, RS232 |
| Efficiency (AC-AC) | ≥ 95% |
To Next Page