Need help?Do you have a question about the RigExpert AA-1400 and is the answer not in the manual?
Instructions for installing batteries and preparing the analyzer for first use.
Procedure for powering the RigExpert antenna analyzer on and off using the dedicated button.
Description of the main menu interface and available commands on the LCD screen.
Explanation of single-point and multi-point measurement modes for antenna analysis.
How to perform open-short-load calibration for improved measurement precision.
Explanation of the theory behind Time Domain Reflectometers and how they locate faults.
Practical steps and controls for using the Impulse Response (IR) and Step Response (SR) graphs in TDR mode.
Using TDR mode to locate faults and discontinuities within a transmission line.
General| Frequency Range | 0.1 to 1400 MHz |
|---|---|
| Weight | 0.5 kg |
| Measurement for 50 and 75-Ohm systems | Yes |
| Calibration | Automatic and manual |
| SWR chart | Yes |
| SWR at fixed frequencies | Yes |
| RF output | Yes |
| PC connection | USB |
| Measurement Accuracy | ± 2% |
| Display | LCD |
| Power Supply | AA batteries or external power supply |
| SWR measurement range | 1.0 to 9.9 |
| SWR display | Numerical |
| Resolution | 0.1 Ohm |
| Measurement types | SWR, Return Loss, Cable Loss, TDR |
| Cable tools | Velocity factor and cable length measurement |
| Memory | 100 measurement results |
| Measurement Type | SWR, Return Loss, Cable Loss, TDR, Distance to Fault |
| R, X range | 0 to 1000 Ohms |
| |Z| range | 0 to 1000 Ohms |
| Impedance Measurement Range | 0 to 1000 Ohms |
To Next Page
