Need help?Do you have a question about the RigExpert AA-230 ZOOM and is the answer not in the manual?
Start the calibration wizard for accurate measurements.
Display and analyze the Standing Wave Ratio (SWR) graph.
Analyze signal power loss due to reflection.
Characterize and locate cable faults using TDR.
Utilize the Smith chart for RF engineering analysis.
Perform open-short-load calibration for accuracy.
General| Frequency Range | 100 kHz to 230 MHz |
|---|---|
| Frequency Entry Resolution | 1 Hz |
| Measurement for 50 and 75-Ohm systems | Yes |
| RF Output | SMA connector |
| Power Charging | USB |
| PC Connection | USB |
| R and X range | 0 to 1000 Ohm |
| Measurement Accuracy (Phase) | ±1° |
| Output Power | 0 dBm (1 mW) |
| Power | 3.7V Li-Po battery |
| Connectivity | USB |
| Operating Temperature | -10 to 40 °C |
| Measurement Type | SWR, R, X, Z |
| SWR measurement range | 1 to 100 |
| Display | 320×240 color TFT |
To Next Page
