Need help?Do you have a question about the RigExpert AA-30 and is the answer not in the manual?
General| Frequency Range | 0.1 to 30 MHz |
|---|---|
| SWR measurement range | 1 to 10 |
| Interface | USB |
| Measurement Parameters | SWR, R, X, Z, Return Loss |
| Frequency entry | Manual |
| Display | Graphical LCD |
| Power | USB |
| Weight | 200 g |
| Measurement for | Antennas |
| Measurement Type | SWR, R, X, Z, Return Loss |
| Battery Life | up to 10 hours |
Details on installing and handling batteries for the analyzer.
Instructions for powering the device on/off and navigating the menu system.
Explanation of the main menu options and indicators for AA-30 and AA-54.
Introduces single-point and multi-point measurement modes for antennas and loads.
Describes how to use the SWR mode for displaying numerical and bar SWR values.
Details the MultiSWR mode for displaying SWR at multiple frequencies on AA-54.
Explains the "Show all" mode for displaying various load parameters and impedance models.
Introduces graphical display of parameters like SWR, R, and X over frequency bands.
How to plot Standing Wave Ratio (SWR) over a specified frequency range.
How to plot resistive (R) and reactive (X) components of impedance.
Describes saving and recalling SWR and R,X graph data in memory slots for AA-54.
Details on accessing and configuring analyzer settings like language, sound, and display.
Explains connecting the analyzer to a PC via USB for data display and firmware updates.
Guidance on checking and adjusting antennas using the analyzer.
Procedures for analyzing coaxial cables, including fault location and length measurement.
Using the analyzer to measure parameters of capacitors, inductors, and transformers.
How to use the analyzer as a source of rectangular waveform RF signal.
To Next Page
