5
3. Precautions
Never connect the analyzer to your antenna in thunderstorms.
Lightning strikes as well as static discharge may kill the
operator.
Never leave the analyzer connected to your antenna after you
finished operating it. Occasional lightning strikes or nearby
transmitters may permanently damage it.
Never inject RF signal into the analyzer. Do not connect it to
your antenna if you have active transmitters nearby.
Avoid static discharge while connecting a cable to the
analyzer. It is recommended to ground the cable before
connecting it.
Do not leave the analyzer in active measurement mode when
you are not actually using it. This may cause interference to
nearby receivers.
If using a personal computer, first connect the cable to the
antenna connector of the analyzer. Then plug the analyzer to
the computer USB port. This will protect the analyzer from
static discharges.
To Next Page
Loading...
Need help?
General
