Need help?Do you have a question about the RigExpert AA-600 and is the answer not in the manual?
General| Frequency Range | 0.1 to 600 MHz |
|---|---|
| Frequency Entry Resolution | 1 Hz |
| Return Loss | 0 to 60 dB |
| SWR at Fixed Frequencies | Yes |
| PC Connection | USB |
| Measurement Parameters | SWR, Return Loss |
| SWR Measurement Range | 1 to 9 |
| R and X Range | 0 to 150 Ohm |
| Calibration | SOL (Short, Open, Load) calibration |
| Cable Tools | Cable length, cable loss, velocity factor |
| Power Supply | Built-in rechargeable battery or external 5V DC |
| Display | 320 x 240 color TFT LCD |
| RF Connector Type | SO239 |
| Output Power | 1 mW |
Instructions for installing batteries and initial setup for the analyzer.
Steps to power the analyzer on and off, and basic menu navigation.
Details the main menu structure and available commands.
Explains single-point and multi-point measurement concepts.
Describes various graphical display modes for analyzing parameters.
Explains and demonstrates the TDR mode for fault location in cables.
Covers various analyzer settings like language, units, and calibration.
Details connecting the analyzer to a computer for data transfer and updates.
Covers checking and adjusting antennas using the analyzer.
Explains measurements related to coaxial cables like length and impedance.
Details measuring parameters of components like capacitors, inductors, and transformers.
Describes using the analyzer as an RF signal generator.
To Next Page
