Rigol DG1022Z - To Set Leading;Trailing Edge Time (Pulse)

Appendix RIGOL
DG1000Z Performance Verification Guide
13
Modulating Waveform Square with 50% duty cycle
Key Frequency 2mHz to 1MHz
PSK
Carrier Waveform Sine, Square, Ramp, Arb (except DC)
Source Internal/External
Modulating Waveform Square with 50% duty cycle
Key Frequency 2mHz to 1MHz
PWM
Carrier Waveform Pulse
Source Internal/External
Modulating
Waveforms
Sine, Square, Ramp, Noise, Arb
Width Deviation 0% to 100% of Pulse Width
Modulating Frequency 2mHz to 1MHz
[Mod/Trig/FSK/Sync] Input
Input Range 75mVRMS to ±5Vac+dc
Input Bandwidth 50kHz
Input Impedance 10kΩ
Burst Characteristics
Carrier Waveform Sine, Square, Ramp, Pulse, Noise, Arb (except DC)
Carrier Frequency 2mHz to 25MHz 2mHz to 30MHz 2mHz to 60MHz
Burst Count 1 to 1,000,000 or Infinite
Start/Stop Phase 0° to 360°, 0.1° resolution
Internal Period 1μs to 500s
Gated Source External Trigger
Trigger Source Internal, External or Manual
Trigger Delay 0ns to 100s
Sweep Characteristics
Carrier Waveform Sine, Square, Ramp, Arb (except DC)
Type Linear, Log or Step
Direction Up/Down
Start/Stop Frequency Consistent with the upper/lower limit of the frequency of