Chapter 5 Disassembly and Assembly RIGOL
Service Guide for DS1000E, DS1000D Series
line 2pin for the screen as well as the power ground wire;
2. Back out both the three bolts ⑤ and the bolt ⑥ on the power board separately
using TORX driver T10 and T20;
3. Backout the two bolts and nuts ⑦ for linking up the power board and shell using
a TORX driver (T10) and remove the power board;
4. Pull out the line 12pin power to fan from the J5 interface of mainboard (locates
under the fan), and then backout the four bolts ⑧ using a TORX driver (T10) to
remove the fan.
To Next Page
Loading...
Need help?
General
