RIGOL Chapter 2 Command System
2-224 MSO7000/DS7000 Programming Guide
:WAVeform Commands
The :WAVeform commands are used to read waveform data and relevant settings. The:WAVeform:MODE
command is used to set the reading mode of waveform data. In different modes, the definitions for the
parameters are different, as shown in Figure 2-1 and 2-2.
Figure 2-1 Parameter Definitions in NORMAL Mode
Figure 2-2 Parameter Definitions in RAW Mode
Note
[1]
: In RAW mode, YINCrement and Verticalscale of the memory waveforms are related to the currently selected
Verticalscale.
Command List:
:WAVeform:SOURce
XINCrement = 1/SampleRate
YINCrement = VerticalScale/25
To Next Page
Loading...
Need help?
General
