RIGOL
DS1000B Service Guide
stresses are variable; for that reason, the transient withstand capability of the
equipment is made known to the user.
WARNING
IEC Measurement Category I. The input terminals may be connected to circuit
terminal in IEC Category I installations for voltages up to 300 VAC. To avoid the
danger of electric shock, do not connect the inputs to circuit’s voltages above 300
VAC.
Transient overvoltage is also present on circuits that are isolated from mains.
DS1000B series digital oscilloscopes is designed to safely withstand occasional
transient overvoltage up to 1000Vpk. Do not use this equipment to measure circuits
where transient overvoltage could exceed this level.
To Next Page
Loading...
