Chapter 1 Quick Start RIGOL
MSO1000Z/DS1000Z User’s Guide 1-11
Pass/Fail:
The instrument can output a negative pulse via this connector when a failed
waveform is detected during the pass/fail test. The instrument continuously
outputs a low level via this connector when no failed waveform is detected.
5． Source Output
The output terminals of the built-in dual-channel source of the oscilloscope.
When source 1 or source 2 is enabled, the signal currently set can be output
through the [Source 1] or [Source 2] connector at the rear panel.
6． Lock Hole
You can lock the instrument to a fixed location using the security lock (please
buy it yourself) via the lock hole.
7． Fuse
If a new fuse is required, please use the specified fuse (250V, T2A). The
replacing method is as follows.
a) Turn off the instrument, switch off the power supply and remove the power
cord.
b) Insert a small straight screwdriver into the slot at the power socket and pry
out the fuse seat gently.
c) Take out the fuse and replace it with a specified fuse. Then, install the fuse
seat.
8． AC Power Socket
AC power input terminal. The power requirements of this oscilloscope are
100-240 V, 45-440 Hz. Use the power cord provided with the accessories to
connect the instrument to AC power. Then, you can press the power key at the
front panel to start the instrument.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
