RIGOL Chapter 1 Disassemble and Assemble
1-12 MSO1000Z/DS1000Z Service Guide
and take off the shield cover gently.
(4) Remove the screw (③) fixing the signal source board using the 5mm
hexagon socket, and take off the signal source board gently.
(5) Remove the screw (②) fixing the main board and front metal plate using
the 5mm hexagon socket.
(6) Remove the 9 screws (①) fixing the main board and front metal plate using
the screwdriver (T10).
(7) Take off the main board gently.
2. To Disassemble the Main Board of MSO1000Z/DS1000Z
Part Explanation:
① 10 screws (torx pan head screw assembly M3*6) fixing the main board and
front metal plate (please remove them according to their actual positions).
Disassemble Steps:
(1) Remove the 4 nuts and washers at the BNC ports on the front metal plate
using the BNC socket.
(2) Remove the 10 screws (①) fixing the main board and front metal plate
using the screwdriver (T10).
(3) Take off the main board gently.
To Next Page
Loading...
