Chapter 2 To Set the Vertical System RIGOL
MSO5000 User Guide 2-1
Chapter 2 To Set the Vertical System
MSO5000 series provides two (CH1-CH2, available to be upgraded to 4 channels
when installed with the MSO5000-4CH option) or four analog input channels
(CH1-CH4), and each channel is equipped with an independent vertical control
system. The setting methods for the vertical systems of the four channels are the
same. This chapter takes CH1 as an example to introduce the setting method for the
vertical system. For this oscilloscope, only CH1 is enabled by default.
Contents in this chapter:
â—¼ To Enable or Disable the Analog Channel
â—¼ To Adjust the Vertical Scale
â—¼ Vertical Expansion
â—¼ To Adjust the Vertical Offset
â—¼ Channel Coupling
â—¼ Bandwidth Limit
â—¼ Probe Ratio
â—¼ Input Impedance
â—¼ Waveform Invert
â—¼ Amplitude Unit
â—¼ Channel Delay
â—¼ Offset Cal
â—¼ Channel Label
To Next Page
Loading...
Need help?
General
