Rigol MSO8000 Series User Manual

RIGOL Chapter 20 System Utility Function Setting
20-2 MSO8000 User Guide
Remote Interface Configuration
MSO8000 series can communicate with the PC via the USB, LAN, or GPIB (requiring
to work with RIGOL's USB-GPIB interface converter) interface. Before using the
remote interfaces, configure the corresponding interface according to the
introductions in the following section.
LAN Configuration
Before using the LAN bus, use a network cable to connect the oscilloscope to your
local area network. The network interface of the oscilloscope is on the rear panel.
Press Utility → IO → LAN to open the LAN Settings interface, as shown in the
following figure. You can view the current network settings and configure the
network parameters.
Figure 20-1 Network Connection Setting Interface
Network Status
Different prompts will be displayed according to the current network connection
status.
⚫ Network Config Succeeded!
⚫ Acquiring IP...
⚫ IP Conflict!
⚫ Disconnected!
⚫ DHCP Config Failed!
⚫ Read Status Fail!
Network Status
Current IP Config.
Type
MAC Address
VISA Descriptor
IP Config. Type
Network Parameters
Web Control Info.

Rigol MSO8000 Series Specifications

General

Brand	Rigol
Model	MSO8000 Series
Category	Test Equipment
Language	English