Volvo Penta EGC
Page 21
is section describes scan tool functions related to marine engines equipped
with Volvo Penta EGC (Electronic Gas Control) fuel injection systems. is
system was introduced on Volvo Penta gasoline marine engines for the 2006
model year.
Connecting to the Volvo Penta EGC System
e TechMate Pro scan tool provides a comprehensive set of diagnostic and
support functions for troubleshooting EGC equipped engines. Connection and
operation of the tool is simple and straight forward.
1) Locate the engine’s diagnostic connector (DLC). e exact location of this
connector is specied in the engine manufacturer’s service manual and may
vary depending upon the engine type. Please be aware that the connector may
have a protective cap attached to it.
Figure 7 Volvo Penta EGC Control Module
2) With the engine’s ignition switch in the OFF position plug the scan tool’s
communication cable into the diagnostic connector. For 2006 & 2007 EGC
systems use adapter #94024, for 2008 and newer systems use adapter #94029.
Volvo Penta EGC Adapter for
2006 & 2007 EGC systems
Rinda Tech P/N 94024
CAN Network Adapter for
2008-Up EGC systems
Rinda Tech P/N 94029
To Next Page
Loading...