Volvo Penta EGC
Page 23
ECM Info data list:
Selecting this data list allows a technician to view version, serial number and cal-
ibration information related to the engine and EGC module. is information in-
cludes a variety of non-diagnostic data including hardware and soware version
numbers, calibration checksums, serial numbers and engine ring order data.
Sea Trial Monitor data list:
e sea trial monitor data list includes a short set of engine parameters that are
useful when performing boat tests. Information available in this data list includes
engine speed, fuel ow rate, engine load and throttle position data.
Injector Monitor data list:
is data list provides a set of ON and OFF voltages for each fuel injector driver.
By viewing the EGC module’s injector output voltage levels a technician can
quickly isolate fuel injector electrical failures.
rottle Monitor data list:
is list is available only when connected to an engine that is equipped with
Electronic rottle Control (ETC). e throttle monitor data list provides quick
access to EGC system parameters that are critical to electronic throttle operation.
A complete set of items related to throttle lever position and throttle blade angle
are provided to assist in diagnosing ETC related problems.
O2 / Misre Monitor data list:
is list is available only when oxygen sensors and catalytic converters are
present on an EGC equipped engine. is data list provides access to O2 sensor,
catalyst and engine misre information.
Special Reset Functions for O2 / Catalyst equipped engines.
Reset Fuel Adapt:
Allows a service technician to clear the ECM’s learned fuel delivery values and
reset the system back to factory default conditions. Consult the engine manufac-
turer’s service literature prior to using this function.
Reset Misre Data:
Clears the ECM’s stored cylinder misre data. Consult the engine manufacturer’s
service literature prior to using this function.
To Next Page
Loading...