Need help?Do you have a question about the Rinnai 1001T and is the answer not in the manual?
General| Model | 1001T |
|---|---|
| Maximum BTU Input | 199, 000 BTU/hr |
| Minimum BTU Input | 15, 000 BTU/hr |
| Ignition Type | Electronic |
| Type | Tankless Water Heater |
| Fuel Type | Natural Gas |
Ensures installation by competent persons per Gas Safety Regs 1994.
Check for defects upon unpacking; do not install if faulty.
For raising room temperature only. Seek advice for other uses.
Appliance is safe if correctly installed and sited per instructions.
Appliance is for NATURAL GAS (G 20) operation only.
Installation must comply with current Building Regs and I.E.E. Wiring Regs.
Recommends fitting a guard for vulnerable persons.
Step-by-step guide for installing sleeve and manifold in standard walls.
Step-by-step instructions for installing the additional flue fitting kit.
Instructions for fitting the floor mounting brackets to the unit.
Guidance on connecting the air inlet hose to the manifold.
Steps to test unit ignition, operation, and thermostat control.
Details earthing, supply, polarity, and general electrical safety rules.
Instructions for connecting external time control devices.
Steps for checking operation before final assembly.
Lists key technical details of the Rinnai 1001T heater.
Provides block and wiring diagrams for the unit's operation.
Contact details for Rinnai UK Ltd. for service and support.
To Next Page