Need help?Do you have a question about the Rinnai Brivis StarPro BX526 and is the answer not in the manual?
General| Category | Gas Heater |
|---|---|
| Model | Brivis StarPro BX526 |
| Gas Type | Natural Gas |
| Heating Capacity | 26 kW |
| Thermostat | Yes |
| Control | Programmable |
Requirements for gas inlet connection, piping, and gas cock fitting.
Guidelines for connecting the heater to the electrical power supply.
Details internal clearances required for installation methods 1 and 2.
Specifies minimum external clearances for SP4, SP5, and SP6 models.
Specifies minimum external clearances for BX5 models.
Step-by-step guide to reconfiguring return air for specific SP430U/SP435U models.
Guide to reconfiguring return air for SP415U/SP421U models.
Steps to reconfigure return air for SP5U/SP6U models (F1-F2 swap).
Steps to reconfigure supply air for SP4 heater cabinets.
Steps to reconfigure supply air for SP5/SP6 heater cabinets.
Instructions for installing the gas feed tube on SP series heaters.
General guidelines and requirements for condensate drain installation.
Step-by-step guide to install a condensate drain for SP6 units.
Guidelines for creating wall cut-outs for heater installation.
Instructions on how to split the heater for easier installation.
Specific steps for splitting the SP4 Universal heater.
Specific steps for splitting the SP5 Universal heater.
Specific steps for splitting SP5 and SP6 Internal heaters.
Specific steps for splitting the SP6 Universal heater.
Requirements and guidelines for installing heaters in a roof space.
Requirements and guidelines for installing heaters beneath the floor.
Formulae and methods for calculating ventilation requirements.
Guidelines for installing heaters externally on the ground or in elevated positions.
To Next Page