Rinnai Granada 252 - User Manual

Questions and Answers

W
wardkatherineJul 28, 2025
Why won't my Rinnai Granada 252 ignite?
- R
  Rebecca WeaverJul 29, 2025
  If your Rinnai Heater won't ignite, first ensure it's properly plugged in and switched on at the power point. A power cut or failure could also be the reason; investigate the cause and allow the unit to cool before attempting to re-ignite it once the power is restored. If it is a new installation, air in the gas pipe may be the issue, which requires purging by a qualified installer. Also, make sure you are pushing the ignition button firmly. For air in the hose, try the ignition again. Finally, check that the gas is turned on at the meter.
T
Travis PriceAug 2, 2025
Why does my Rinnai Granada 252 keep cutting off?
- D
  Darrell BowenAug 3, 2025
  If your Rinnai Heater cuts off at all settings, it's likely due to the oxygen depletion system operating. To resolve this, ensure the room is well-ventilated.
M
Mark CameronAug 7, 2025
What to do if I smell gas coming from my Rinnai Granada 252?
- B
  Brian SullivanAug 7, 2025
  If you smell gas from your Rinnai Heater, immediately turn off the gas supply. This indicates a gas leak, and you should schedule a service call for professional assistance.
J
Jeffrey ManningAug 12, 2025
What to do if my Rinnai Heater goes out when I release the ignition button?
- C
  Catherine MasonAug 12, 2025
  If your Rinnai Heater goes out when you release the ignition button, it could be due to a blocked gas filter or a faulty fan. In either case, schedule a service call to address the issue.
A
Alyssa HillAug 18, 2025
Why does my Rinnai Heater take so long to heat the room?
- D
  Derek MurphyAug 18, 2025
  If your Rinnai Heater is taking too long to heat the room, the room may be too large for the heater's capacity. Check with the retailer to confirm if the heater is appropriately sized for your space.
J
Jordan DavisAug 22, 2025
Is it normal for the fan to stop when Rinnai Granada 252 Heater is turned off?
- T
  timothy37Aug 23, 2025
  This is normal operation.