Rinnai 12 Commercial Manifold Pack OIM
Only Rinnai Flueing systems can be used with Internal Water Heaters. Non-Rinnai Flueing
systems are not certied and will not be covered under warranty.
For all further information on internal ueing, please refer to separate Flueing Manual supplied with ueing
components.
MULTIPLE FLUE TERMINALS
Dimension 'H' in AS/NZS 5601 Figure 6.2 does not apply when multiple Rinnai external water heaters of the same
model are installed on the same vertical face with ue terminals at the same height (i.e. side by side). Under these
conditions appliances can abut each other as shown below:
Before commencing installation, ensure you refer to the content of all other Operation / Installation manuals
supplied with the appropriate model Rinnai Continuous Flow Water Heater or Rinnai Flueing Systems.
INSTALLATION INSTRUCTIONS
To Next Page