22
Using High Temperature Display Controllers.
You will need to program the Master controller if you want to display and use
temperatures over 50
0
C. Programming only needs to be done on Master universal
controllers; other universal controllers will not allow this, and Deluxe Kitchen Controllers
are supplied already programmed to allow high temperatures. Temperatures in
bathrooms should never exceed 50
0
C.
STEP 1: On the Master controller only press and hold the Transfer and On/Off
buttons simultaneously (see fig 2.) until a “beep” is heard (approx. 5 seconds)
STEP 2: When the Primary controller is switched on it should be possible to select
temperatures higher than 50ºC. If not repeat STEP 1.
Note:
If the master controller is replaced, repeat STEP 1 above for the new controller.
TEMPERATURE CONTROLS - OPERATING
To Next Page
Loading...
