What to do if Rinnai Water Heater starts then the water goes cold?
If your Rinnai Water Heater starts but the water goes cold, verify that the power is still on and try opening your hot water tap further.
What to do if my Rinnai REU-VRM2632WC has no ignition or gas supply?
If your Rinnai Water Heater has no ignition or gas supply, check that the gas is turned on at both the water heater and the gas meter or cylinder.
What to do if my Rinnai Water Heater starts then the water goes cold?
If your Rinnai Water Heater starts but the water goes cold, verify that the power is still on. Additionally, try opening your hot water tap further.
Why does my Rinnai REU-VRM2632WC Water Heater start and then the water goes cold?
If your Rinnai Water Heater starts and then the water goes cold, verify that the power is still on. Also, try opening your hot water tap further.
What to do if there is a power interruption during bath fill with my Rinnai Water Heater?
If there's a power interruption during a bath fill and water won't flow on power reinstatement with your Rinnai Water Heater, turn off all hot water taps and press the On/Off button twice.
What to do if Rinnai REU-VRM2632WC water will not flow on power reinstatement?
If you experience a power interruption while filling a bath and the water doesn't flow when power is restored to your Rinnai Water Heater, turn off all hot water taps and press the On/Off button twice.
How to resolve a condensate pipe blockage in my Rinnai Water Heater?
To resolve a condensate pipe blockage in your Rinnai Water Heater, check for any blockages on the condensate drain path.
How to check for condensate pipe blockage in Rinnai REU-VRM2632WC Water Heater?
If you suspect a condensate pipe blockage in your Rinnai Water Heater, check the condensate drain path for any obstructions.
How to fix noticeable reduction in water flow in Rinnai REU-VRM2632WC Water Heater?
If you notice a reduction in water flow with your Rinnai Water Heater, the inlet water filter may need cleaning. A service call is recommended.
What to do if there is power interruption during bath fill with my Rinnai REU-VRM2632WC?
If you experience a power interruption during a bath fill and the water will not flow when the power is restored, turn off all hot water taps. Then, press the On/Off button twice.
General| Type | Tankless |
|---|---|
| Fuel Type | Gas |
| Condensing | Yes |
| Venting Required | Yes |
| Gas Type | Natural Gas |
| Temperature Range | 98°F - 140°F |
| Category | Residential |
| Maximum BTU Input | 199, 000 BTU/h |
| Minimum BTU Input | 15, 000 BTU/hr |
| Venting | PVC, CPVC |
| Vent Length | Up to 60 ft |
| Electrical Requirements | 120V, 60Hz |
| Ignition Type | Electronic |
| Warranty | 12 years heat exchanger, 5 years parts, 1 year labor |
To Next Page
