To Next PageTo Next PageHow to fix a noisy Rinnai Zen I24?
If your Rinnai Boiler is making unusual noises: 1. Ensure the boiler is correctly and securely attached to the wall. 2. If the noise comes from the air inlet/exhaust pipe, call Rinnai service to inspect the flue system. 3. If the noise originates from the hydraulic circuit, remove air from the pipes by opening the manual drain point.
Why is the domestic hot water from my Rinnai Zen I24 Boiler not hot enough?
If the domestic hot water from your Rinnai Boiler isn't hot enough: 1. Adjust the hot water temperature using the remote control. 2. Be aware that hot water volume decreases when used in multiple locations simultaneously. 3. Adjust the amount of cold water mixed with the hot water.
How to troubleshoot if my Rinnai Zen I24 Boiler is not heating the room enough?
If the room isn't heating adequately with your Rinnai Boiler, consider the following: 1. Ensure the CH (Central Heating) mode is activated on the remote control. 2. Increase the set heating temperature. 3. Adjust or disable reservation/outgoing mode. 4. Reduce or stop domestic hot water usage. 5. Open any closed heating valves. 6. Connect the remote controller and adjust CH settings. 7. Clean the CH return filter. 8. Remove air from the pipes by opening the manual air drain point.
What to do if I smell exhaust gas from my Rinnai Boiler?
If you smell exhaust gas from your Rinnai Boiler, immediately stop the boiler and contact Rinnai service or maintenance for assistance.
Why is there no hot water coming from my Rinnai Zen I24 Boiler?
If there is no hot water from your Rinnai Boiler, consider these possible causes: * Ensure the DHW (Domestic Hot Water) mode is active by pressing the DHW button on the remote control. * Confirm there is a water supply to the boiler and wait for water availability. * Check that the water pressure is not too low, as the boiler requires a minimum flow rate of 2.3 liters per minute to start. * Make sure the cold water supply valve is fully open.
Why does my Rinnai Zen I24 have ignition failure?
If your Rinnai Boiler fails to ignite, there are several potential causes: 1. Check if the boiler is properly plugged into an outlet with the correct voltage. 2. Ensure the set temperature on the display is higher than the current temperature. 3. If error code 11 is displayed, turn the boiler off and then on again. 4. Verify that the gas supply valve is open, ensuring gas is available to the boiler.
What to do if I smell gas coming from my Rinnai Zen I24?
If you smell gas, immediately stop the Rinnai Boiler and gas supply. Open all windows and doors to ventilate the area. Do not operate any appliances to prevent potential explosions. Contact your gas supplier and regularly inspect the gas pipes and shut-off valve for leaks.
General| Model | Zen I24 |
|---|---|
| Heating Capacity | 24kW |
| Weight | 32 kg |
| Boiler Type | Combi |
| ErP Heating Efficiency Class | A |
| ErP Water Heating Efficiency Class | A |
| CH Energy Efficiency (%) | 94% |
| NOx Class | 5 |
| Fuel Type | Natural Gas |
