50
To record a Lap-time push the LAP/RESET button while the Chronograph
is running. The digits will stop to show the lap-time. Push the LAP/RESET
button again and the accumulated time will re-appear on your screen.
(This procedure can be repeated for any number of laps).
Notes: 1. To view the current time and date, while the Chronograph is
running, simply press the MODE button once. The Normal Time screen
will appear and the ( ) will flash to show that the Chronograph is still
running.
2. The [ ] Chronograph screen will display the accumulated
time in Minutes, Seconds and 1/100 Seconds until the accumulated time
is less than 1 hour, after which the screen will display Hours, Minutes
and Seconds.
[ ] Alarm Mode:
By choosing a time, an alarm will sound each day at
the preset time. The alarm is a strong chime and can
be immediately shut off by pushing any button or will
automatically shut off after 30 seconds.
[ ] Countdown Timer:
A count down timer with duration from 1 second to
99 hrs, 59 min, 59 sec. Note that the timer type is
Count down – Count up.
In [ ] Modes, simply push the START/STOP to
commence and stop the Timer. Then push the LAP/
RESET to reset to the preset value while the timer is stopped. When the
Timer is running the ( ) symbol will flash and the days will scroll along
the top of the screen.
At the end of the countdown a double beep tone sounds for 30 seconds.
As a warning, a double beep tone will sound once when 1 minute or 30
seconds is left. Finally, a single beep tone sounds for the last 10 seconds
before the end of the set time.
Notes: To view the current time and date, while the Timer is running,
simply press the MODE button once. The Normal Time screen will appear
and the ( ) will flash to show that the Timer is still running.
To Next Page
Loading...
