3
LED Indicators:
Power LED (Green)
On: Power OK.
Rapid Flash: AC trouble.
Slow Flash: Low battery
trouble.
Trouble LED (Orange)
Rapid Flash: Trouble.
Off: No trouble.
Arm/Alarm LED (Red)
On: System armed.
Rapid Flash: Alarm.
Slow Flash: System in Exit
Delay.
Stay LED (Red)
On: System armed at STAY.
Off: System disarmed.
Ready LED (Green)
On: System ready.
Off: Open zones.
Slow Flash: Ready to arm
with open entry/exit zone.
Sound Indicators:
Intrusion alarm:
Fire alarm:
Exit delay:
Entry delay:
Confirm operation:
Reject operation:
Arm/Disarm squawk:
Continues rapid beeping.
Staggered rapid beeping.
Slow buzzer beeps until the Exit Delay time period expires.
Slow buzzer beeps until the Entry Delay time period expires.
A one-second tone.
Three rapid error beeps.
1 siren chirp: System armed,
2 siren chirps: System is disarmed,
4 siren chirps: System disarmed after an alarm.
Edit User Codes:
1. Press and enter your code.
2. Scroll to the option Codes/Tags and press
.
3. Scroll to User Codes/Tags and press
.
4. Select the option New/Change and press
.
5. Scroll to select the User Index number to which you want to assign a user code and press.
6. Enter and re-enter the new code followed by
.
7. Repeat the above steps for additional codes.
Assign Proximity Tag:
1 . Follow steps 1-3 of the Edit User Code above.
2 . Scroll to Proximity Tags and press
.
3 . Select the option New/Change and press
.
4 . Scroll to the User Index number to which you want to assign a tag and press
.
5 . Within 10 seconds, hold the proximity tag at a distance of 1 to 2 cm from the keypad’s keys.
6 . Repeat the above steps for additional codes.
To Next Page
Loading...
Need help?
General
