Risco GT Plus - System Commands and Indicators; SMS Commands; LED Indicators - Elegant Keypad

09/2020 Page 7 5IN2907
SMS Commands
NOTES: Command words are not case sensitive. A separator between command words
may be used (or not). To receive an acknowledgement reply, add RP to the end of an SMS
command.
Full Set: code + S (Example: 1234S) Get system status: code + ST
Part Set: code + P Omit Zone: code + OM + zone
number
Group Set: code + G + select group A--D
Un-omit Zone: code + UNOM + zone
number
Full Unset: code + US View last alarm : code + AL
Partition Full Set: code + S: + partition number
Change FM number: code +
FMPHONE +
FM serial number + NEW + new
phone number
Partition Part Set: code + P: + partition number
Activate Output: code + POON + PO
number
Deactivate Output: code + POOFF +
PO number
Multiple Partition Full/Part Set: code + S/P: +
partition number A, + partition number B, +
partition number C, etc.
Get SIM credit level: code + CR
Partition Unset: code + US: + partition number
Multiple Partition Unset: code + US: + partition
number A, + partition number B, + partition
number C, etc.
LED Indicators – Elegant Keypad
Power LED
On: Power OK.
Off: No power
Rapid flash: System fault.
Slow flash: System is
programming
Ready LED
On: Ready to set
Off: Not ready to set
Slow flash: Ready to set
while entry/exit zone is
open
Set LED
On: System in fully set mode
Off: System unset
Rapid flash: Alarm
Slow flash: System in Exit
Delay
Partial Set / Omit LED
On: System in partially-set or
zone-omited mode
Off: No omited zones
Tamper LED
On: Tamper alarm
Off: No tamper alarm
Fire LED:
On: Fire alarm
Off: No fire alarm
Flash: Fire circuit fault