Installation and Programming Manual 3-81
ACCESSORIES: ADD/DELETE MODULE (cont’d)
Quick Key Item Default Explanation
ADD/DELETE
MODULE (cont’d)
---
7 1 6 Wireless Button
Module
Not for UL
Installations
NONE the Wireless Button Module
is a wireless receiver add-on
designed to process signals from up to eight handheld
Wireless Button
(arm/disarm/panic) transmitters
at this display:
using either the UP- or DOWN-arrow keys, position
the cursor over the Wireless Button Module’s I.D.
number for which you wish to assign (or delete) such
a unit
the first (or only) Wireless Button Module must be
assigned to the first I.D. number, which is “1”
be sure that the selected Wireless Button Module has
been physically programmed with the same I.D.
according to the supplied instructions
with the cursor positioned over the “TYPE” field, press
[STAY] to choose either “NONE” or WBT8 (the only
such module); see the note on the next page
at this display, you will begin to assign any
individual handheld Wireless Buttons to one (or more)
of the system’s partitions
to do so, use either the UP- or DOWN-arrow keys to
position the cursor over the field corresponding to the
Wireless Button’s I.D
enter the I.D. number of the first button transmitter
you wish to assign
position the cursor over the Partition field and enter
the number (from 1-8) of the partition to which the
Wireless Button will be assigned; press [ENTER]
repeat the process for any other Wireless Button
Modules and Wireless Buttons intended for the
system
once done, press [.] to return to the previous
programming level
SSIGN TO PAR:
BUTT=01 PAR=1
INSTALLER PROG:
7)ACCESSORIES
↓
L BUTTON MODL:
ID=1 TYPE=NONE
To Next Page
Loading...
