Installation and Programming Manual
3-82
ACCESSORIES: ADD/DELETE MODULE (cont’d)
Quick Key Item Default Explanation
ADD/DELETE
MODULE (cont’d)
---
Wireless Button Module (cont’d)
7 1 6
PLEASE NOTE:
the following display will appear if a Wireless
Button Module is found and “NONE” has been selected;
if so:
• press [ENTER] to return to the prior display
OR
• press the [STAY] key to select “Y”, and press
[ENTER] to confirm the delete
7 1 7 Printer Module
Not for UL
Installations
NONE
at this display:
• using either the UP- or DOWN-arrow keys, position the
cursor over the Printer Module’s I.D. number for which
you wish to assign (or delete) such a unit
• the first (or only) Printer Module must be assigned to
the first I.D. number, which is “1” (the system can
support two such modules)
• with the cursor positioned over the “TYPE” field, press
the [STAY] key to toggle between and choose among
the four selections given:
• NONE
• PRNE (prints Panel Events)
• PRNA (prints Access Control Events)
• PRN2 (prints both
of the above events)
• once the proper selection is made, press [ENTER] to
store your choice and to repeat the process for if there
is a second Printer Module in the system
• once done, press the [.] key to return to the previous
programming level
PLEASE NOTE
:
the following display will appear if a Printer
Module is found and “NONE” has been selected; if so:
• press [ENTER] to return to the prior display
OR
• press the [STAY] key to select “Y”, and press
[ENTER] to confirm the delete
PRINTER MODULE:
ID=1 TYPE= NONE
..DELETE..
RE YOU SURE? N
..DELETE..
RE YOU SURE? N
INSTALLER PROG:
7)ACCESSORIES ↓
To Next Page
Loading...
