Installation and Programming Manual
3-50
CODE MAINTENANCE: CODE LENGTH
Quick Key Item Default Explanation
4 6
CODE LENGTH ---
• the Code Length specifies the number of digits
(either 4 or 6) which must be used by the Grand
Master, Manager, and Master Codes
• all other codes (i.e. User, Arm Only, Maid) may be
between one-digit and the number of digits
specified through this parameter
• press [ENTER] to make your selection
4 6 1 4 digits
4 6 2 6 digits
use either the DOWN-arrow or UP-arrow keys to
display either 4-digit or 6-digit codes as described
above
press [ENTER]
if you make a change in the Code Length, the
following display will appear:
use the [STAY] key to change the default “N”, if
desired;
press [ENTER]
NOTE 1: if the Code Length parameter is changed
after any User Codes have already been stored, they
may have to be changed to conform to the new
parameter
NOTE 2: if a 6-digit Code Length is selected, system
default codes like 1-2-3-4
, 0-2-9-6, and 0-2-9-9 will
become 1-2-3-4-0-0
, 0-2-9-6-0-0, and 0-2-9-9-0-0,
respectively
NOTE 3: REMEMBER–only authorized system users
(i.e. Grand Master, Manager, Master) may determine
the numbers which comprise the actual User Code(s)
INSTALLER PROG:
4)CODE MAINT.
↓
CODES SHOULD BE
DELETED. SURE
To Next Page
Loading...
