Page 6
Sub-section 1:
When using the glass platen
Step 1
Open the platen cover.
Step 2
Place an original on the glass
platen.
Place the original with the scanning side facing
down and align the center of the original with
the arrow mark.
When a gauge cover is attached on
the glass platen, place the original
under the gauge cover
.
You can lift the gauge cover from
the lower right.
Step 3
Close the platen cover.
Close the platen cover gently.
Forcefully closing the platen
cover will cause damage to the
glass platen or original scanning
errors.
Sub-section 2:
When using the auto document
feeder
Step 1
Place originals on the auto
document feeder.
Place the originals with the scanning side
facing up.
For the auto document feeder, the
size and the number of originals
to be placed are limited.
Step 2
Adjust the ADF original guides to
the width of the original.
This machine identifies the
original size by recognizing the
positions of the
ADF original
guides. If the ADF original guides
do not fit tightly to the original,
the original size cannot be
identified correctly.
To Next Page
Loading...
