ritetemp 6020 - User Manual

PG 1
PG 2
Statement of use: The 6020 can be used with millivolt,
24VAC, 1 and 2 stage conventional gas/oil/elec heat, 1 and 2
stage heat pumps, 2 or 3 wire zoned hot water, zoned forced
air, 1 and 2 stage cooling and hybrid systems. 
It cannot be used with 120 volt heating systems.
HEAT
HEAT
COOL
OFF
FAN
AUTO
ON
TEMP
UP button
TEMP DOWN button
Temperature
Display
HEAT/COOL
Mode Switch
Fan
Switch
Configure
Set HEAT/COOL mode switch to HEAT or COOL. The unit will display the
Room temperature. Set the Fan switch to AUTO.
Press the TEMP UP and TEMP DOWN buttons to select the desired
temperature. The TARGET icon will be displayed with your desired
temperature. (Display will return to room temp in 5 sec).
In the winter, set the system switch to HEAT to control your heating system.
In the summer, set the system switch to COOL to control your AC.
In spring and fall or when windows are open, 
you can set the system switch OFF.
Setting the FAN switch to AUTO automatically runs your system's fan during
heating and cooling.
Setting the FAN switch to ON runs your system's fan continuously even
without heating or cooling.
Operate
Farenheit/Celcius
indicator
Current Temperature
Display
SET Temperature
Display
ROOM TEMP TARGET TEMP
Operation 6020

Summary

Thermostat Configuration and Operation

Configure Mode and Fan Settings

Set HEAT/COOL switch to HEAT or COOL, and Fan switch to AUTO to display Room temperature.

Operate Temperature and System Controls

Use TEMP UP/DOWN to set target temp. Select HEAT/COOL/OFF for system, and AUTO/ON for fan.

Low Battery Warning

Battery Replacement Procedure

Low battery icon flashes; replace AAA batteries. HVAC stops on power loss. Press RESET after replacement.

Temperature Unit Selection

Fahrenheit;Centigrade Jumper Setting

Jumper #5 selects display units. Off is Fahrenheit (default); on both pins is Centigrade. Reset after change.

Heat Pump Auxiliary Mode

Set Auxiliary Heat Only Mode

Move jumper 1 [heat pump] to position 2 [Aux only] for auxiliary heat operation.

ritetemp 6020 Specifications

General

Type	Programmable Thermostat
Display	LCD
Programmability	7-day programmable
Hold Feature	Yes
Filter Change Alert	Yes
Weight	0.5 lbs
Power Source	Battery (2 AA)
Compatibility	Single-stage heating and cooling systems