Need help?Do you have a question about the ritetemp 6036 and is the answer not in the manual?
General| Brand | ritetemp |
|---|---|
| Model | 6036 |
| Category | Thermostat |
| Language | English |
Use a firm push or tap on the main display to select functions.
The HOME screen displays when the unit is operating your system.
Set the temperature display to Celsius (°C) or Fahrenheit (°F).
Adjust the time of day using the left and right arrows.
Select the current day of the week.
Configure the temperature difference for system cycling.
Set reminders for filter replacement based on runtime.
Toggle the audible chirp sound on or off.
Lock or unlock program settings by touching the icon for 2 seconds.
Define the start time for each program period.
Choose the day of the week for programming target temperatures.
Choose the specific time slot to program.
Copy the current day's program to another day.
Cycle through the programmed settings.
Use arrows to raise or lower the target temperature.
Cycle through days to select the current day.
Use arrows to set the time, hold for faster setting.
Toggle between Celsius (°C) and Fahrenheit (°F) display.
Enable or disable the musical note chirp.
Thermostat comes preprogrammed with an Energy-Star approved program.
Select HEAT or COOL to run the Energy-Star program.
Shows programmed temperatures for HEAT and COOL modes.
Choose the day and time slot for programming.
Use UP/Down arrows to set the target temperature.
View programmed settings for each day/time slot.
Copy program settings from one day to another.
Adjust target temperature temporarily until next time slot.
Set a permanent hold temperature until manually removed.
Use Temp Up/Down arrows to select the hold temperature.
Determines temperature difference for HVAC system cycling.
Battery icon flashes when batteries are low and need replacement.
Lock settings to prevent changes (Level 1/2).
Toggle the time display between 12-hour and 24-hour formats.
Tracks furnace runtime to remind of filter replacement.
Sequential staging for faster recovery with auxiliary heat.
Jumper setting for electric, gas/oil aux heat or aux only.
Compatible with millivolt and 24VAC heating/cooling systems.
Set desired temperatures using UP/DOWN arrows on touch screen.
Minimum 4-minute off time protects heating and cooling systems.
Uses sequential staging for comfort and faster response.
Thermostat is factory calibrated to +/- 1°F.
Adjust temperature reading +/- 6° to match other thermometers.
Press HOME to save the new calibration setting.
To Next Page
