PG 15
On the HOME screen, the humidity in the room is
displayed. This thermostat can control the humidity level
with the proper equipment installed in the HVAC system.
Maximum Humidity setting (Requires air conditioning and COOL mode)-
This thermostat can be used to de-humidify by turning on the air conditioning
as a function of humidity. Cooler air cannot hold as much moisture.
To set the MAX humidity level desired -
ï From the
MENU screen and touch MAX.
ï U
se the up/down arrows to set the MAXimum humidity level you desire.
NOTE: The air conditioner will then be controlled by both humidity and/or temperature.
Either one coming on will reduce the temperature and the humidity.
Minimum Humidity setting (requires a built-in humidifier and HEAT mode)-
This thermostat can be used to humidify by turning on a humidifier in the
furnace. Connect the H terminal on the 8082C to the humidifier control relay.
To set the MIN humidity level desired -
ï
From the MENU screen and touch MIN.
ï U
se the up/down arrows to set the MIN humidity level you desire.
NOTE: When the humidifier is turned on, the fan will also come on automatically.
4 Special Features cont.
HUMIDITY
PG 16
This device complies with Part 15 of the FCC Rules. Operation is subject to the follow two
conditions: (1) This device may not casue harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user`s authority to operate the equipment.
Remote Control frequency 312MHZ
To Previous Page
Loading...
Need help?
General
