To Next PageTo Next Page
Need help?Do you have a question about the Ritron RCCR and is the answer not in the manual?
Configures the radio to enable specific channel zones for operation using the keypad.
How to select AAR channels using the numeric keypad and CHAN button for operation.
Using the numeric keypad or DTMF button to create and transmit DTMF sequences.
Using the TONE button to send AAR single-tones for dispatch.
Using the DISP button to transmit DTMF or Single-Tone codes.
Understanding the TX and RX indicator lights on the display.
Adjusting front-panel speaker volume using the VOL button.
Using the PTT button to transmit voice messages from the microphone.
Automatic adjustment of display brightness based on ambient light.
Selecting up to 500 custom Home Channels using the HOME button.
Toggling between the last two TX-RX channel pairs using HOME and #.
Understanding 'INVALID' and 'ANTENNA' error messages.
Details of the 19-pin, DB15, and DB9 connectors on the rear panel.
Details of the 12-pin Auxiliary and 4-pin Power connectors on the side panel.
Details of the 19-pin and 6-pin connectors for the remote head.
Initial steps and requirements for programming the radio.
Steps to connect the radio to a computer for programming.
Overview of the main interface of the RCCR Programmer software.
Reading Radio Definition Files (.rdf) for programming or review.
Saving current radio configuration to a Radio Definition File (.rdf).
Printing a pre-formatted report of radio programming.
Printing a list of custom frequencies programmed in the radio.
Printing a list of all Home Channels and their programming.
Reading the current configuration from the radio.
Writing programmed settings from the software to the radio.
Updating the radio's firmware with new revisions.
Accessing the NXDN programming screen if the radio has this capability.
Opening a PDF file with the complete AAR Frequency Table.
Opening the programmer help guide (PDF format).
Setting minimum volume, handset volume, and auxiliary speaker volume.
Configuring DTMF/Tone timers, TX timeout, and keypad entry timers.
Enabling AAR channels, dispatch sequences, and antenna fault detection.
Disabling specific front-panel keypad buttons.
Displaying radio identification like firmware and serial number.
Programming up to 500 custom Home Channels for receive/transmit.
Programming TX/RX Tone, Invert DCS, and Dispatch Codes for analog channels.
Programming TX/RX RAN, Dest. ID, RX Group, Squelch Type, and Call Type.
Programming up to 100 custom frequencies not included in AAR tables.
Configuring Unit IDs, Unit Names, Group IDs, and Group Names for NXDN.
Performing radio test and alignment using the Align screen.
Information on RF energy, FCC/IC regulations, and user awareness.
Details on how the radio complies with national/international RF exposure standards.
Guidelines and instructions for controlling RF exposure during operation.
Guidelines for installing mobile antennas and approved accessories.
Information on accessories tested for RF exposure compliance.
List of Wideband, Narrowband, and Digital AAR channels and frequencies.
Technical specifications for the RCCR radio, including general, transmitter, and receiver details.
Detailed receiver specifications including sensitivity, rejection, and I.F. system.
Details on minimum/maximum supply voltage and current consumption.
Details of the warranty coverage, exclusions, and service process.
General