Ritron RCCR - Single-Tone

OPERATING THE RADIO
-----------------------------------------------------------------------------------------
---------------------------------------------------------------------------------------------------------------
Ritron RCCR Clean Cab User Manual 5
CHAN Button Disable
The CH
AN button can be disabled using the Ritron RCCR programmer. When disabled the HOME
button must be used for channel selection.
To enter a Wide Band AAR frequency pair press:
1
2
CHAN
CHAN
7
4
T/D HOME
TX RX
TX RX
1. CHAN button
2. Digit 1 of the 2-digit AAR channel for TX
3.
Digit 2 of the 2-digit AAR channel for TX
4.
Digit 1 of the 2-digit AAR channel for RX Resulting Display
5. Digit 2 of the 2-digit AAR channel for RX
6. CHAN button or
wait 2 seconds
To enter a Narrow Band AAR frequency pair press:
T/D HOME
TX RX
TX RX
2
CHAN
7
4
0
1
1
1. CHAN button
2. Digit 1 of the 3-digit AAR channel for TX
3.
Digit 2 of the 3-digit AAR channel for TX
4.
Digit 3 of the 3-digit AAR channel for TX Resulting Display
5. Digit 1 of the 3-digit AAR channel for RX
6. Digit 2 of the 3-digit AAR channel for RX
7. Digit 3 of the 3-digit AAR channel for RX
For Quick Entry of an AAR frequency pair with the same TX/RX press:
T/D HOME
TX RX
TX RX
1
2
CHAN
CHAN
0
1. CHAN button
2. Digit 1 of the AAR channel
3. Digit 2 of the AAR channel
4. Digit 3 of the AAR channel (if narrowband) Resulting Display
5. CHAN button or
wait 2 seconds