Rittal CMC-TC Master - Safety Instructions

5
1. Safety instructions
Rittal
CMC-TC
General remarks
The installation and operating instructions contain basic information for installation,
for putting into operation, and for operating the RITTAL CMC-
TC Master. It is a
must to make the instructions available to the installation technician and the
administrative operating personnel and that they should read these carefully.
RITTAL cannot accept liability for personal injury and material damage resu
lting
from non-
observance of the safety advice in the installation and operating
instructions.
It is essential to observe not only the general safety advice given
in this chapter, but also the special safety advice given in the other chapters.
Personnel qualification and authorization
Operation and any changes may be c
arried out only by authorized specialist
personnel or by authorized trained operating personnel.
!
Risks due to non
-
observance of safety advice
Non-observance of the safety advice may result in risks for the personnel,
as well
as to the RITTAL CMC-TC Master together with the connected equipment. Non-
observance of the safety advice involves loss of the right to claim for all and any
damages.
IPxx

ϑ
min
ϑ
max
Working at the CMC
-
TC
The generally applicable electrical regulations of the country i
n which the unit is
installed and operated must be observed, just as the existing national regulations
for the prevention of accidents and any internal rules (work, operating, safety
regulations) issued by the operator. Prior to working at the unit this mu
st be
disconnected from the supply and secured against being switched on again.
Original accessories and accessories authorized by the manufacturer ensure
safety. The use of other parts may make void the liability for consequences
resulting from this. Repa
ir work at the unit may be done only by RITTAL or by
authorized personnel.
Operating reliabilit
y
The operating reliability of the unit supplied is only warranted in case of use as
intended and according to the rules. The limit values quoted in the technical data
(see Appendix B Technical data
) must not be exceeded under any
circumstances. This appli
es particularly to the allowed ambient temperature range
and the allowed IP protection category. For applications with a higher specified IP
protection category the Rittal CMC-
TC must be installed in an enclosure of a
higher IP protection category, complyi
ng with the specified protection category.
Operation of the CMC-
TC system in direct contact with water, aggressive media,
or inflammable gases and fumes is prohibited.
