RIX Industries MAN-2PS2B-N2 Page v
Safety Precautions
Safety precautions are necessary for the protection of personnel and equipment. Prior to any
attempt to install, operate, maintain, troubleshoot, or repair any part of the compressor, all
warnings and cautions included here and/or appearing throughout this manual should be
thoroughly reviewed and understood.
This symbol means if the danger is not avoided, it will cause death, serious
bodily injury, or severe damage to the machine.
1. Before working on the compressor, all internal pressure must be relieved, and compressor
must be isolated or disconnected from all external pressure sources.
2. All electrical components associated with this equipment shall be installed and grounded in
accordance with applicable codes and regulations.
3. Before working on electrical equipment, take steps to ensure system is de-energized and
will remain so while work is in progress. All circuits not known to be DEAD must be
considered LIVE and dangerous at all times.
This symbol means if the warning is not heeded, it can cause death, bodily
injury, or damage to the machine.
4. Do not operate unit if safety guards are removed, damaged, or modified.
5. Do not reset relief valves for any pressure higher than as specified in this manual.
6. Do not make any unauthorized alteration to equipment.
This symbol means if precaution is not taken, it may cause bodily injury or
damage to the machine.
7. Do not touch cylinder heads or discharge gas lines from the heads up to the heat exchanger
inlets. These are hot and can cause serious burns.
To Next Page
Loading...