WARNING! Do not clean the glass before waiting for its cooling. Suddenly changes
in temperature may cause breakings in the glass.
5.11 WOODBOX EXTRACTION
The woodbox is endowed with a sliding rails system that allows an easy closure. It would be
enough to juxtapose the box to close it automatically. For cleaning or other reasons it could be
necessary to remove the woodbox. To do this, it is necessary to extract the woodbox to limit
switch, then lift it slightly and at the same time extract it again. To reinsert the woodbox repeat
the operations in the opposite sense.
WARNING! Do not put flammable products in the woodbox! The objects placed
inside must not reach the upper wall of the woodbox.
5.12 PLATE CLEANING AND MAINTENANCE
Radiating plates in special steel need regular maintenance, in particular they need cleaning after
every use that brings moisture or dust on the plate itself.
With cold cooker or thermal cooker you have to remove all the pots and boilers that could
maintain moisture on the plate. Together with the device are given some exclusive products,
studied for the cleaning and the maintenance of the plate: the abrasive sponge, the plate cleaner
and the oil for plate care. On how to use them please read the instructions written on the bottles.
The plates are all worked in with non acid anti-corrosion oil. The use of the cooker deletes this oil
layer and so the contact with water may cause small rusty stains. In this case you have to wipe the
plate with a rag with the plate cleaner given together with the device. If the rusty stain is not being
cleaned, you could have to wipe the plate with the abrasive sponge or with a lightly abrasive
paper. To restore the protecting layer wipe the plate with little oil for plate care.
In any case, cleaning with water must be avoided.
It is important to be sure that the expansion cuts and the hole between the plate and the frame
are not obstructed by dust or by other residuals: the plate could suffer deformations, also
permanent. When it is necessary, you should clean also the beating of the circled removing
eventual residuals. Radiating steel plates, exposed to continuous heating, trend slowly to take a
burnished colour; if you want to accelerate the process, repeat frequently the wiping with oil for
plate care.
When the cooker has not been used for a long time it is suggested to treat the plate with the oil
for plate care, in this way the plate is protected against moisture in the best way. To remove the
plate, you have to lift it up. When you reinsert the plate, keep in mind to leave the 1 or 2
millimetres to allow the thermal expansion of the plate itself.
5.13 HANDLES MAINTENANCE
When it is necessary to replace or to tighten the handles of the fire door or the oven door it is
essential to follow the correct sequence of the conic washers, see picture 30.
To Next Page
Loading...
