4
IMAE02-E3
3. SETTING FOR COMMUNICATION
In order to make communication between the digital indicator AE500 and the host computer, it is
necessary to set the device address, communication speed, data bit configuration and interval time.
Communication settings are made in communication setting mode.
The section in each picture is dimly lit.
3.1 Transfer to Communication Setting Mode
1. Turn on the power to the AE500. Thus, the input type and PV display change in this order.
2. Pressing the SET key while the shift key is being pressed when PV display is being displayed
selects communication setting mode. In this mode, device address Add are displayed in the first
place.
In order to terminate the communication setting mode, press the SET key while pressing the shift
key. After the communication setting mode terminates, the display changes to the PV display.
Communication setting mode
SET
SET
ALM4
ALM1 ALM2 ALM3
PV display
Device address
ALM4
ALM1 ALM2 ALM3
To Next Page
Loading...