RKC INSTRUMENT AE500 - Communication Parameter Selection

To Next Page

To Previous Page

3. SETTING FOR COMUNICATION

IMAE02-E3

3.2 Communication Parameter Selection

Parameters in communication setting mode are selected in the order of device address Add,

communication speed bPS, data bit configuration bIT and interval time set value InT. Each parameter

is selected by pressing the SET key.







Display flowchart

Input type display

Power on

(Display for approx. 4 sec)

Display changes automatically

PV display

Press the SET key while pressing the shift key.

Device address

(add)

Communication speed

(bPS)

Data bit configuration

Interval time set value

(InT)

Press the

SET key.

Press the SET key

while pressing the

shift key.

Press the SET key.

Communication setting mode

PV display