RKS MX25 - Rear Wheel and Handlebar;Stem Assembly

08
COMPONENT ADJUSTMENT
A. Installaton of the Rear Wheel
ATTENTION: Please make sure the both ends have occluded tghtly and evenly. Wheel groups are at the central
poston.
The hub of the front wheel s grouped nto two types: the nut-type and the quck-release type. A 15# open/box
spanner s necessary for the net-type whle the quck-release type can buckle or release tself wth the buckle.
The Assembly of the Handlebar and Stem
1.Nut-type front wheel groups
2.15# open/box spanner
3.Torque: 160-250KGf.cm
(16N.m-25N.m)/
4.Make sure wheel groups are at
the central poston
1. Quck-release front wheel
group
2. Make sure the bub occludes
the front fork, and make sure
there s no devaton
Stem s grouped nto two types: The tooth-
type and the non-tooth-type
1.The tooth-type stem
2.Turn the M6 hexagon tool clockwse.
3.Torque: 100-120KGg.cm
9.8N.m-12N.m）。
4.Make sure the stem shares the
same drecton wth your rdng.
ATTENTION
SAFETY LINE SHOULD BE
FOLDED, OR THERE MAY
EXIST POTENTIAL RISKS
MX25