RKS MX25 - Disc Brake and Line Management

1.The adjustment of the dsc brake; tool: a M5 hexagonal screwdrver.
2.Fx the lne onto the dsc brake.
3.Please make sure a more than 1mm gap between the brake dsc and the brake pad.
4.If there s any frcton, please adjust the nuts.
5.Bolts for adjustment nclude the bolts on the brake handle.
6.If you squeeze the brake, they are n standard condton when they are n lne wth the bar.
1.Cut theextra part of the brake lne.
2.Enclose the end of the brake lne
for both of the dsc brake and the V brake.
1.Thread the brake lne through the
brake handle, and take t out from
the hole of the bolt.
2.The end of the brake lne should
be folded nto the hole of the bolts.
1.For effect pcture, see the
pcture.
2.Ths s the bolt for fine
adjustment
3.Adjustment s only for V brakes
and dsc brakes.
1.Enclose the end of the brake
lne to prevent the lne from
spreadng apart whch would
hurt people.
12
COMPONENT ADJUSTMENT
MX25