Roadtrek Simplicity 2019 - Utilities and Water Systems; Fresh and City Water Supply

32
© Erwin Hymer Group North America, Inc., R00
Utilities
Just like your house, your Roadtrek has fresh water, electricity, waste water disposal, heating, and cooling
systems. In the Roadtrek, these systems are self-contained and travel with you.
Your vehicle should be reasonably level to allow normal operation of the system.
Fresh Water
Your fresh water tank uses a gravity fill system, located in the driver's side door pillar. You can fill the fresh water
tanks from a convenient water spigot.
To fill the tanks with fresh water, open the driver's side front door and remove the orange plug in the fresh water fill
port. (Picture 31.1) Fill until water comes out the hole.
City Water
The city water connection is in the rear, underneath the rear bumper on the passenger's side. (Picture 31.2)
Unscrew the white plastic protective cap and connect your clean hose to the water faucet and this
connection point. Turn the faucet on and check for leaks, tightening the connections as necessary.
There is a pressure regulator in the connection. See HOWTO: Potable Water Use for
instructions on how to hook up to city water.
City water connection
Fresh water tank fill
location
Picture 31.1
Picture 31.2