11
5
. Insert with caution a at-tip screwdriver between the metal sheet of the frost module (4) and the frost holder
(5) and gently turn the screwdriver to break a force of magnets (6) on the frost holder (5) and pull the light
frost module (4) out from the xture
. The Frost module (4) is fastened to the frost holder (5) by means of
the four magnets (6).
6
. Insert new frost module in the frost holder (5). Check, that both slots (8) snapped correctly into
two protrusions (7) on the frost holder (5)
7. Screw
the fan assembly (2) back to the xture and place the plastic cover back on the xture before
applying power.
To Next Page
Loading...
